TWEETER POD
TWEETER POD
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
TWEETER POD
INSTALLATION INSTRUCTIONS
Congratulations and thank you for your purchase of Hogtunes HF-1 Tweeter
Pod. Since positive word of mouth is the best way to grow our business, we
want your new speakers to work as well as they were designed to. If you have
any questions or concerns, we are here to help. Email or call us during regular
business hours. If you still need help, then please consider a professional
installation by your dealer.
2
Hogtunes Contact Information
Email: [email protected]
USA Tel: 608-554-7631
•
Canada Tel: 705-719-6361
Step #1: Remove the ground
wire from the
battery, or make sure
your ignition switch
stays in the “OFF”
position. Remove
your outer fairing/
headlamp assembly,
and set it aside.
Refer to a service
manual if you need
help with this.
Step #2: NOTE: If you
already have a Fairing Dash Pad (HD Part # 58262-05) remove the unit
from the bike, and skip to Step #5. Your kit comes with a small triangle
shaped “drilling template” with two 1/8” (3mm) holes in it. Please note
one side says “clutch side” and the other side says “brake side”. There
is a “V” formed in the inner fairing plastic where the drilling template
fits into. On the brake side of the bike, hold the drilling template “in”
this “V” so the words “brake side” are showing. Using a 1/8” (3mm)
drill bit, drill the pilot holes, repeat for the clutch side and enlarge all
4 holes to 5/16” (8mm).
Summary of Contents for HF-1 HOG POD
Page 1: ......
