HOW IT WORKS
The solar panel charges the built-in rechargeable battery in just 5-6 hours. During the day, the solar panel converts sunlight into stored electricity
and automatically illuminates for 8-12 hours once night falls. All you need to do is switch it ON, install it in the desired position, and enjoy the light in
the evening.
Figure 1
Figure 2
Figure 3
INSTALLATION INSTRUCTIONS
Part 1
Part 2
Part 3
1.
Press the on/off button to switch the light on. The switch is located at the side of the product. (Fig.1)
2.
Put up the installation gauge (part 2) at the place where you wish to install the light. Drill two holes (about 100mm apart, Fig.2). Put in the
wall plugs and screws. The screws need to stick out the wall about 0.5mm (Fig.3). Now you can hang the product on the screws.
Note:
Place the lamp away from other light sources, bright lights can prevent it from automatically illuminating. Place the lamp where it can get 5-6
hours of direct sunlight.
BATTERY REPLACEMENT
To ensure your light's optimal performance, we recommend replacing the battery every 2-3 years.
Just be sure to open the housing unit with care and replace it with the same 3.2-volt, 500mAh
#14500 battery.
1.
The battery is located underneath the solar panel. To get access to the battery, unscrew the
back cover of the light.
2.
Carefully open the compartment and check if the wires are intact.
3.
Remove the old battery and replace it with 1 new lithium iron phosphate battery.
4.
Close the battery compartment and place back the cover with screws. Make sure it’s
properly sealed.
EN
