Page 1-10
Chapter I Introduction
!! IMPORTANT NOTE !!
Shutting Down the Computer
To avoid damaging important files It is
necessary to shut down Windows
®
properly
before turning off or restarting the aligner
or the computer.
Use the following steps to shut down the aligner
from within the
Alignment software:
1. Return to the Home Alignment screen.
2. Power off the PC using Software control,
the “SHUT DOWN WINDOWS
®
” icon at
the lower right corner of the Home Screen
followed by turning the switch off at the
rear of the aligner.
Note: The switch must remain off a
minimum of 10 seconds before it can
be turned back on.
From the Windows
®
desktop:
1. Close any programs or applications that
may have been opened.
2. Click the Start button, and then click Shut
Down.
3. On the Shut Down Windows
®
box that ap-
pears, select “Shut down the computer?”
Click “Yes” to proceed.
4. The computer will automatically shut-
down. After the computer finishes shutting
down, turn the switch off at the rear of the
aligner.
Note: The switch must remain off a
minimum of 10 seconds before it can
be turned back on.
Summary of Contents for Pro42
Page 1: ...Operators Manual Portable Imaging Alignment Systems with Pro42 ...
Page 2: ...Blank page ...
Page 8: ...Page 8 Table of Contents ...
Page 65: ...NOTES ...
