HOFFRICHTER GmbH · Mettenheimer Straße 12 / 14 · 19061 Schwerin · Germany
Phone: +49 385 39925 - 0 · Fax: +49 385 39925 - 25 · E-Mail: [email protected]
Web: www.hoffrichter.de · VECTOR et 2.140 Patient kurz-eng-280711-01, Art.-no.: 5000 0455
WEEKLY CLEANING OF THE DEVICE
1. Disconnect the power plug from the socket.
2. Wipe the device with a cloth slightly moistened with soapy water. Then use a dry
cloth to wipe the device dry.
CLEANING THE HEAD GEAR
Clean the head gear as required:
1. Disconnect the head gear from the mask.
2. Clean the head gear as described in the head gear manufacturer’s user’s manual.
CLEANING
DAILY CLEANING OF THE MASK
1. Separate mask and therapy tube.
2. Use mild soap water (don´t use other additives) for cleaning, thoroughly rinse with
clear water and let the mask dry at the air. Protect it from direct sunlight exposure.
WEEKLY CLEANING OF THE THERAPY TUBE
1. Before cleaning close the measuring tube using the stoppers.
2. Use mild soapy water for cleaning, thoroughly rinse with clear water, and let the tube
dry at the air.
3. Remove the two stoppers from the measuring tube after cleaning.
If there is water remaining in the measuring tube pressure measuring may nega-
tively affect the therpay.
REPLACING THE FILTER CASSETTE
If the
fi
lter is polluted or the display shows the message
, the
fi
lter cassette must be replaced.
1. To replace the
fi
lter cassette, pull it out of the device.
2.
Replace
fi
lter cassette and
fi
lter frame cover.
3.
Replace the
fi
lter cassette by a new one.
4. Insert the new
fi
lter cassette onto the
fi
lter frame cover.
Make sure the upper part (slit) and the
fi
lter cassette
(pin) are in the correct position.
5. Reset the
fi
lter counter. Press the enter key
. Then
select
with the programing keys
and
. Press the enter key
twice.
Never operate the device without
fi
lter cassette. Only
and exclusively use original HOFFRICHTER
fi
lter cas-
settes.
$*#!%(/!.
@ ;$
4
Setting heating level:
1. Press the heater key until the heater menu is shown.
2. Press the enter key
. The display of the heating level starts
fl
ashing.
3. Using the programing keys
and
to set the desired hea-
ting level. Level 1 represents the lowest and level 5 the maxi-
mum heat output.
4. Con
fi
rm the setting using the enter key
.
4%/!*1
Q!/%*#MMMMMMMMMMMMMM=
4%/!*1
Q!/%*#MMMMMMMMMMMMMM=
HUMIDIFIER AquaDROP et (optional)
Press the heating key to
switch on
the humidi
fi
er’s heating. The display now shows
the currently set heating level and the heater LED lights.
Press the heating key again to
switch off
the humidi
fi
er’s heating. The heater LED goes
off. For more information please see AquaDROP et
-
user‘s manual.
Connect the humidi
fi
er:
Detach the humidi
fi
er from the device:
2
1
