32
7.5
After using the device
1. Switch off the device and place it in the base in a safe place, on
a stable and flat surface resistant to high temperatures.
2. Unplug the device and wait until it cools down.
3. Pour the remaining water out of the tank, see point
7.2 Refilling
the water tank
.
4. Wait for the water tank to dry fully and store the steamer
in a safe place.
Caution!
Risk of scalding! The emitted steam is hot!
Never aim the steam stream at other people. The steam is hot
and may cause scalding!
Never aim the steam stream directly at electrical devices or devices
with electrical components (TV set, radio receiver, electric stove).
Do not aim the steam stream at unprotected wooden surfaces,
unsuitable grouts, cold glass, or plastics.
The device can operate as long as there is water in the tank. When
the tank is empty, disconnect the device from the mains, wait for it
to cool down, refill the water in the tank, and continue working.
7.6
Brush attachment installation/removal
CAUTION! Do not install/remove the attachment when the device
is hot, as there is a risk of scalding.
1. Make sure the device is cooled down and disconnected from
the power source.
2. Grab the device by the handle, install the attachment with
the other hand. Make sure the tabs on the attachment inner
side enter into the openings around the steam plate.
3. To remove the attachment, pry and take
the attachment off.