SPC-E Mounting Guidelines
Page 2
Hochiki Europe (UK) Ltd
2-3-0-798/ISS2/MAR08
Starting at the emitter end, the cover
should be opened (refer to Fig.3.)
the field wiring can then be
connected either from behind the
detector or from below the detector,
depending on the suitability of the
installation. If the wires are to come
in from below, then it will be
necessary to break the knock-out
slot from the bottom of the detector
body (located near to the retaining
clip).
Fig.2
Hook the back of the detector body to the 4 prongs of the mounting plate and slide down firmly, ensuring that the cables
are not trapped or damaged by the detector.
The stripped wires should be pushed into the holes of the connector whilst the white push key is pressed with a small
screwdriver, this will enable the wire to push completely home, the white push key can then be released, and this should
then grip the cable securely.
The Receiver
should then be
connected next.
Firstly open the
Receiver cover
(refer to Fig.3.)
and then connect
the field wiring
either from behind
or below the
detector,
depending on the
suitability of the
installation.
The Receiver
can then be
mounted onto
the Interface kit
by aligning the
four mounting
slots on the rear
of the Receiver
with the four
mounting hooks
on the mounting
bracket and then
sliding the
Receiver down
gently. The
cables should be
terminated as
shown in Fig.1.
or Fig.2.
Fig.3
