25) Attach the starboard boom.
Lift the star-
board boom
from the trail-
er and install
the pin from
the mast into
the hole in the
plastic block
on the boom.
Again, the
plastic block
has a detent
ball in it and
will require a
short, quick
push or pull to
get the boom
on or off.
26) Attach and tension the out-
hauls.
Be sure the lines are straight and hook the
outhaul hook to the clew of the sail. Tighten
the outhaul and cleat it in the jam cleat. A
bungi cord will pull the excess line into the
boom for storage.
27) Install the sail link.
Note the stickers that identify the port and
starboard ends of the sail link. While on the
trailer, the starboard side is to rear. The pad
eye near the center of the sail link should be
up. Lift the sail link from the trailer and rotate it
counter-clockwise to attach the ends to the
booms. Note that the pad eye is about 5” to the
starboard of center line.
Be sure that the stainless tabs on the booms
are horizontal and not vertical before attaching
the sail link. If the booms are reversed, con-
necting the sail link will damage it by prevent-
ing normal rotation. Be sure that the connect-
ing pin inserts as shown above.
28) Position the mast rotator
bars.
Lower the mast rotator bar to the forward-
pointing, horizontal position and attach the
grey rotation line. Attach the rear rotation
inducer line (green) to the eye strap located on
the rear lower mast base.
29) Install the seat.
The smaller ID tube goes down and forward.
Install the forward tube and install the rear tube
in the corresponding slot in the rear support.
For example, if the forward tube is in the sec-
ond slot from the front, the rear tube will be the
second slot from the front. The seat should
have good tension in it.
Now the boat is ready.
When you are ready to launch, remove the
trailer tie-down bungi from the center beam
area.
NOTE: When launching the boat lift with your knees and not
your back.
Foil retract line
Mast rotator
Sensor retract line
Sail link
12
Summary of Contents for TriFoiler
Page 1: ...ASSEMBLY MANUAL...