9
Bundle up the extra transducer cable and power cable wire and lightly
wrap a wire tie around each of them to keep it organized. DO NOT CUT THE
EXCESS WIRES ON THE TRANSDUCER CABLE TO SHORTEN THEM. THIS
WILL RUIN THE QUALITY OF THE SIGNAL TO THE TRANSDUCER. We also
recommend that you attach the wires to something in the kayak to keep
them from sliding around (like the sail mast base or scupper). If you have a
large bundle, you can link the wire ties together to form a bigger loop. DO
NOT PUT EXCESSIVE TENSION ON THE WIRE TIE. IT SHOULD ONLY HOLD
ENOUGH PRESSURE TO HOLD THE WIRE IN PLACE.
The terminal cap can be used to put over fishfinder power cable plug to
prevent corrosion.
12V Battery Charging Instructions: Plug the battery in to the battery char-
ger making sure the tab on the
male pigtail aligns with the clip on the female pigtail. Plug the battery charger
in to an electrical outlet. If the light on the charger turns red the battery is in
need of charging and should remain plugged in until the light turns green. A
green light means the battery is charged and the charger has switched to
trickle charge. At this point it is ready to be unplugged from the socket and
used.
Connecting Power Cable to Power Source
14
15
