STEP 1
Fin key is located in the
center fin box
STEP 2
Back out the fin screw
until side fin box is clear
STEP 3
Insert fin with flat side
toward the center of the
board and slide the fin fully
back in the box and then
lever the front of the fin
down into the box.
STEP 4
Tighten screw snuggly
“DO NOT OVER TIGHTEN“
SIDE FIN INSTALLATION
TROUBLESHOOTING: CENTER FIN FIT
On Ocaasion, there may be a fit issue with the center fin, either too tight or too loose. This
is not an uncommon problem and can be easily fixed
Tight Fin
Take the center fin as shown, and gently use a sanding block
with 60 grit sandpaper ( recommended) or equivilent.
Sand at a slight angle taking more material off at the base of the
fin until edge becomes slightly beveled. Do this 4-5 times and
then try to insert the fin again. Repeat as necessary. Be sure to
only sand the base area of the fin that fits into the fin box
Loose Fin
Take the center fin as shown, and place a piece of masking tape
or equivilent on the fin as shown.
(Some boards do not have side fins)