EN
5
BNF • RTF
Super Cub S
Assembly
Landing Gear Installation
Transmitter Binding
The included RTF transmitter should be bound to
the aircraft at the factory, but if you need to re-bind,
follow the binding procedure as shown.
You need to ‘bind’ your chosen Spektrum
™
DSM2
®
/
DSMX
®
technology equipped aircraft transmitter to
the receiver for proper operation. Please refer to the
optional parts list in this manual or visit
www.bindnfl y.com for a list of compatible transmit-
ters.
Binding Procedure Reference Table
1.
Make sure the transmitter is powered off.
BIND PLUG
2.
Make sure the transmitter controls are
neutral, the throttle and throttle trim are
in the lowest position, and the aircraft is
immobile.
3.
Install bind plug in the receiver bind port.
4.
Connect the fl ight battery in the aircraft.
The receiver LED will begin to fl ash.
5.
Power on the transmitter while holding
the transmitter bind button.
6.
When the receiver binds to the transmit-
ter, the light on the receiver will turn
solid. The motor will arm with throttle and
throttle trim at the lowest position.
7.
Release the Bind button and remove the
bind plug from the receiver.
8.
Disconnect the fl ight battery from the
aircraft, then power off the transmitter.
The receiver should retain the binding instructions
received from the transmitter until another binding
is done.
x4
Bag A
5
2
2
5
4