3
Main Parts:
Transmitter battery installation:
It may be necessary to loosen and remove the 2 Phillips screws on the battery cover of the transmitter to install
•
the batteries.
Open cover
•
Install 4 x AA batteries (check polarity)
•
Close cover
•
Note: Charge the flight battery with your transmitter
Charging Your Millennium NTU:
The Millennium NTU’s charger ensures an accurate charge every time.
During the charge cycle it continually monitors the battery’s current and
voltage.
1. Make sure the transmitter and Millennium NTU power switches are
turned OFF.
2. Attach the transmitter’s charge lead (in the bottom of the
transmitter) into the charging port on the Millennium NTU. Make
sure the red dot on the charge lead faces the rear of the
Millennium NTU to prevent damage to the battery.
3. The LED indicator on the transmitter will be solid when the battery
is being charged and then the LED will flash when the battery is
close to full. The LED will go out when the battery is fully charged.
1
2
3
4
5
6
7
8
9
10
11
12
Main Rotor
Stabilizer
Connecting Shaft
Tail Rotor
Charging Port; On/Off Switch
Landing Gear
Tail Boom Weight
Steering Trim
Steering
Throttle
Power/Charge Indicator
Power Switch
8
9
10
11
12
1
2
3
4
6
7
5