10
11
8
9
©2017 Horizon Hobby, LLC. HobbyZone and the HobbyZone logo are registered trademarks of Horizon Hobby, LLC. Cub Crafters, Carbon Cub, associated
emblems and logos, and body designs of vehicles are either registered trademarks or trademarks of Cub Crafters, Inc. and are used with permission.
US 9,056,667. US 8,672,726. D774,933.
Created 08/17
56510EN
HBZ3200, HBZ3250
Holding Pattern/Return to Home
After Your Flight
Virtual Fence
Wind
500ft (150 m)
Circle Virtual Fence, Small (Default):
setting keeps the aircraft in a 500 ft
radius fl ying area. The aircraft will not
fl y outside of this boundary. If the
aircraft approaches the boundary, it will
automatically bank to stay within the
allowed fl ying area.
Home Position
OFF
Press and release
to return to home
Pilot
Holding Pattern (HP) Mode
If at anytime the aircraft seems too far away, press and release
the HP/AL (bind) button on the transmitter.
The aircraft will maneuver to an altitude of approximately
120 feet (36m) and begin to fl y a circular pattern over the
home location.
The aircraft fl ies fully autonomously when HP mode is active.
The transmitter sticks have no control.
NOTICE:
As a safety precaution, Holding Pattern mode will not function when your
aircraft is below an altitude of approximately 20 ft (6m).
To deactivate HP mode and regain control, press and release the HP/AL button again or
change fl ight modes.
IMPORTANT
:
When the HP feature is activated, the aircraft should immediately respond to the command. If the aircraft does not
respond immediately, GPS signal may have been lost. In this case, the aircraft will have to be fl own back to the home location manually.
Landing With AutoLand
To land, hold the HP/AL button for 3 seconds and let go
of the control sticks. The aircraft will immediately turn to align
itself for an upwind approach and maneuver to an altitude of
approximately 65 ft (20m) and 295 ft (90m) downwind from
the takeoff point. The aircraft will then turn into the wind and
begin the fi nal approach. The control sticks are still functional
and can be used to avoid obstacles.
As the aircraft passes over the runway threshold, pull the throttle stick fully back and use up
elevator to fl are the aircraft to a soft touch down on the runway. This is the best practice for
landings and will help prevent accidental propeller strikes.
The aircraft will land into the wind near your takeoff point and come to a complete stop.
NOTICE:
As a safety precaution, AutoLand mode will not initiate when the aircraft is
below an altitude of approximately 20ft (6m).
Press and release the HP/AL (bind) button or change fl ight modes at anytime to abort the AutoLand approach.
CAUTION:
Never attempt to catch a fl ying aircraft in your hands. Doing so could cause severe personal injury and
damage to the aircraft.
Home Position
Pilot
Wind
Press
again
to abort
landing
Hold for 3 sec.
to land
Do not approach the aircraft until the propeller has stopped spinning.
When you are done fl ying, disconnect the battery and remove it from the
aircraft, then power off the transmitter.
NOTICE:
Always keep hands, hair and loose clothing away from
the propeller when disconnecting the battery.
Inspect the airframe for loose or damaged parts.
