ENGLISH
FRAN
Ç
AIS
DEUTSCH
ESP
A
Ñ
OL
6
Functions
Battery LED Indicator
Battery Installation
Warning:
Never disassemble batteries or put the batteries in fire, chemical
agents, otherwise they may cause personal injuries or property damages.
Battery Disposal:
Observe corresponding regulations about wasted battery
treatment regulations.
1. After running out of power, dispose of wasted batteries in designated
areas far away from water supply, household areas and planted areas.
2. Submit the wasted batteries to specific recycling stations.
KT2S+ Transmitter
Steering Wheel :
Control direction (Left / Right) of the RC
model.
Throttle Trigger :
Control speed and direction (Forwar-
d/Brake/Backward) of the driving model.
Battery Compartment Tray :
Cover and hold the batteries powering the
transmitter.
Antenna :
Transmit signal to the model
Power ON / OFF :
Power ON / OFF the transmitter
SYNC & Battery Indicator :
Top Green LED light indicates synchroni-
zation status
and/or adequate battery power supply.
ATV :
Adjustable Steering Rate by ATV dial
ST. Trim Dial :
Adjust the neutral position of steering
servo when model wheels are straight
ahead.
TH. Trim Dial :
Make sure the model stays still when
releasing the throttle trigger.
EPA :
End Point Adjustment
WARNING: accidental or intentional EPA function manipulation
may cause servos malfunction (reduced or inexistant travel).
Please reset maximum default values before contacting your
dealer (see «EPA», on page 7).
Works with 4 x 1.5V AA
Batteries (not provided),
KT2S+ can be operated a
few hours. Installation:
Remove the battery
compartment cover as
shown below.
Install the batteries
observing the polarity
marked on battery
compartment.
Then reicompart-
ment cover as the
picture shown
below.
- During normal operation, the LED should be solid green ON-
- When battery voltage is dropped below 3.8V, the LED will become red
color and flashing very slowly, to indicate battery is low, you should replace
new battery as soon as possible
* Always turn on the transmitter first by sliding the switch on the left side
from bottom to top. The green lights above the switch should light up. If not,
you need to check for low or incorrectly installed batteries.
1. Steering : Adjust the steering trim to
keep the front wheels in straight line
when steering wheel remains in
NEUTRAL position.
2. Throttle : Adjust the throttle trim to
ensure the wheels stop rotating when
throttle trigger remains in NEUTRAL
position (only for nitro).
For EP vehicles, this button must be
set to NEUTRAL (See «1- The neutral
point on page 9).
Pre-Run Check
LED
indicator
Indicator
LED
Battery
Compartment Tray
Steering Trim Dial
Steering Wheel
Throttle Trigger
Throttle Trim Dial
BIND / EPA Key
Antenna
Power Indicator
ATV
Power
ON / OFF
Throttle
Reverse Switch
Steering
Reverse Switch
TRANSMITTER
EVEN IF THIS CAR IS A READY TO RUN KIT, YOU STILL HAVE SOME LITTLE THINGS TO DO TO FAMILIARI ZE WITH YOUR
PRODUCT.
PLEASE FOLLOW THESE STEPS.
