43
7. Installation of electrical
devices
To disconnect the electric connection
• Switch off the automatic circuit breaker
l
by pressing the
rocker button down
m
.
• Remove the CEE connector plug
k
.
• Press the cover flap
j
down until it clicks into place.
Automatic circuit breaker with FI ('fast interrupt')
switch
Only plugs and cords that comply with CEE standards
must be used.
To connect to a mains hook up point
• Pull out the 13-pin plug that connects to the tow vehicle.
• Switch off the automatic circuit breaker
l
by pressing the ro
-
cker button down
m
.
• Take hold of the bottom of the cover flap of the CEE external
socket
j
and pull it up (see Chapter 5.2 Cover Flaps).
• Completely unwind the mains cable.
• Open the cap of the CEE connector plug by pulling it up in a 90°
angle.
• Insert the plug
k
until it locks into place.
• Switch the automatic circuit breaker
l
back on.
Connected 230V hook up
Always first unhook the caravan from the car before
setting up the 230V mains connection.
Rules for the mains connection
• Use only a 3 x 2.5 mm² cable with a maximum length of 25 m, a
CEE connector plug and connector to connect the caravan to an
external 230V mains.
When you are using a cable drum, this
must
be complete
-
ly unwound, when the caravan is in use (drawing mains
power), as otherwise induction may cause the cable to
heat up, which could lead to a fire (provided there is no
protection against overheating).
Protecting the 230V system
The 230V system is protected by a two-pole 13A automatic circuit
breaker
l
, which is located in the storage locker underneath the
kitchen drawer.
4
3
1
2
