3
The rudder should now be aligned with the centre line of the hull,
once this is ok, put the sticker provided in place to cover and
waterproof this rebate and rudder assembly.
ASSEMBLE THE MAST AND SAILS
First join the 2 sections of the mast and fix with the 2mm black
screws provided.
Now unroll the main sail and thread the bead in the front of the sail
down through the groove in the mast, from the top to the black
fitting near the bottom of the mast, this must be done quite carefully
to avoid tearing the sail.
Now fit the mast cap or top hat ensuring the long arm is on the
same side of the mast as the groove.
Now it is time to stand the mast! Sit the base of the mast in the hole
provided in the deck checking that the black mast base is in place.
Take the lines from just under the cross piece on the mast and
hook them on to each end of the fitting on the side of the yacht and
tighten using the black sliding blocks. Now take the lines from the
top of the mast that pass through the cross piece and hook these to
the rear of the fitting on the sides of the yacht and tighten. The
mast should now stand on its own.
