❏
1. Position the wing, centered on the fuselage. The
two indentations on the top of the wing should be
aligned with the center of the fuselage. Secure the wing
with two rubberbands.
❏
2. Attach two additional rubberbands, crossing them
over the top of the wing.
❏
1. Remove the antenna
from box and insert it in
the top of the transmitter.
Screw the antenna into
the antenna base tightly.
Do not overtighten.
❏
2. The transmitter that controls your airplane requires
power, in the form of eight “AA” batteries. To install the
batteries, just turn over the transmitter, remove the battery
hatch and install the batteries following the diagram inside
the battery compartment. Reinstall the battery hatch, switch
on the transmitter and check the LEDs on the front of the
transmitter. If the green light is on, it is safe to fly. If only the
red light is on or flashing, you need to install fresh batteries.
❏
3. On the bottom of the transmitter are two switches.
Both switches should be positioned to the left.
Caution:
•
Do not use rechargeable (NiCd) batteries.
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc) or
rechargeable (NiCd) batteries
PREPARE THE TRANSMITTER
INSTALL THE WING
5
