●
Lithium Polymer (LiPo) Battery:
Rechargeable battery which is used to power the airplane. LiPo batteries are
lighter and smaller than most other types of rechargeable batteries.
●
Transmitter (TX):
This is the hand-held unit that sends the signal to the control unit, or receiver (RX).
●
Receiver (RX):
This is part of the power module that responds to input from the transmitter.
●
Rudder:
The flight control on the airplane that controls turning direction. This will yaw the plane so that the nose
points in toward the direction of the turn and will cause the wings to roll into the turn.
●
Elevator:
The flight control that controls pitch attitude. By adding power and pitching up, you can make the model
climb or loop.
●
Center of Gravity (C.G.):
Point at which the aircraft must balance in order to fly properly.
●
Glide Slope:
The proper path for an airplane approaching a landing strip.
●
Binding Button (or Trim Reset Button):
Binding is a dedicated relationship between a 2.4GHz transmitter and
receiver, in which the receiver responds to input from the transmitter. Once this relationship is established the
units are bound. The binding button may also be used to reset the elevator and rudder to the original position
established when the module is installed on the airframe (not recommended during flight). It is recommended to
use the Binding Button when changing airframes.
GLOSSARY
PREPARE THE TRANSMITTER
Install (4) “AA” batteries (included).
Right Stick
Elevator / Rudder
Control Surface Trims
Left Stick
(Throttle)
Binding Button
(or Trim Reset Button)
Mixing Dial
USB Charger Port
Power Switch
4
Summary of Contents for ItCanFly Uberlite 1
Page 11: ...11 notes ...
Page 12: ... ...
