❏
4. Install two (2) new “AA” batteries into the lighting
system battery holder as shown. Be sure to follow the positive
(
+
) and negative (
–
) pattern molded into the battery holder.
❏
5. The lighting system has its own dedicated power switch.
Turn the power “ON” to illuminate the running lights. If the
lights appear to be dim or do not illuminate at all, this is an
indication that the batteries need to be replaced.
❏
6. Run the receiver antenna up through the antenna tube
located at the rear of the cabin as shown.
❏
7. Affix the three plastic radar pieces atop the cabin
as shown.
BATTERY PACK INSTALLATION
❏
1. Peel the backing off of the supplied hook & loop
material and apply the “loop” side to your 6-cell battery pack.
With the cabin removed from the deck, place a fully charged
battery pack onto the battery tray as shown.
IMPORTANT! Never leave a charger and battery pack
unattended while charging.
Use only the recommended battery pack and an
appropriate charger.
Do not attempt to charge the battery while it is installed
in the Atlantic Harbor Tugboat.
Refer to the instructions included with your charger for
proper battery charging procedure.
4
