•
Exercise time can be set in advance, when it approaches the preset time, the monitor will
alarm 10 seconds. The maximum pre-set time is 99 minutes.
•
Display Body Mass Index (BMI).
3.DISTANCE/BMR
•
Count the total distance from exercise start to the end and the range is 0.00 ~ 9.99 ~ 99.9KM.
Or,if the meter showing M, the range will be 0.00 ~ 9.99 ~ 99.9 MILE.
•
Exercise distance can be set in advance, when it approaches the preset distance, the monitor
will alarm 10 seconds. The maximum pre-set distance is 99.9KM or MILE(if the monitor
showing M).
•
Display Basal Metabolic Rate(BMR).
4. CALORIES/TEMPERATURE
•
Count the total calories consumed from exercise start to the end and the range is 0.0 ~ 99.9 ~
999KCAL.
•
The calorie value can be set in advance, when it approaches the preset calorie, the monitor
will alarm 10 seconds.
•
Display room temperature(TEMP).
5. PULSE
•
Measure the your heart rate per minute. The range is 40 ~ 240bpm.
•
It will display “P” to pause the pulse test if there is no pulse signal
over 60 seconds. You can
press UP or DOWN to enter the pulse test again.
6.AUTO ON/OFF & AUTO START/STOP
•
Without any signal of exercise or operation for 8 minutes, the power will turn off
automatically and all the memory will be cleared off except body fat parameters and
temperature.
•
Once receive exercise or operation signal, the monitor will turn on automatically.
Operation
1.
SET
Press MODE to choose the display window that needs to be pre-set, and the value in relevant
window will flash. Then press UP/DOWN to increase/decrease the value to reach your want alarm
time, alarm distance, or alarm calorie. Hold UP/DOWN to increase/decrease the value rapidly. Press
RESET to reset value in relevant flashing window.
2. PULSE RATE
Before measuring your pulse ra
te, press any button to change “P” into “0” in the window, then enter
pulse mode. Please place both your palms on the contact pads and the monitor will show your
current heart beat rate in beats per minute (BPM) on the LCD after 3~4 seconds.
Remark: During the process of pulse measurement, because of the contact jamming, the
measurement value may be higher than the virtual pulse rate during the first 2
～
3 seconds, then will
return to normal level. The measurement value cannot be regarded as the basis of medical
treatment.
