HMS H6504, Manual

Page: 26 / 59

return to normal level. The measurement value cannot be regarded as the basis of medical
treatment.
Note: If the computer is equipped with wireless heart rate measuring via the transmitter belt, before
measuring your pulse rate, please wet the conductive pads on the underside of the transmitter with
water, sweat or a conductive gel to ensure a good contact.then wear the belt across the chest. Adjust
the belt until the transmitter sits snugly below the pectoral muscles for an accurate heart rate signal.
3. PULSE RECOVERY
In non-setting and non-exercising status, first test your pulse as above mentioned. Then press
RECEOVERY/UP to enter pulse recovery function. The display will show 1 minute count-down as well
as your pulse rate. Hold on the pulse sensor or wear the transmitter belt (IF HAVE) until it counts
down to zero. Then, it will pop up your pulse recovery level from F1 to F6, that is, from the fastest
recovery to slowest. The fastest recovery F1 show the best. Press RECOVERY/UP again to exit pulse
recovery function.
4. BODYFAT, BMI & BMR
•
In non-exercising status, press BODYFAT to enter body fat parameters settings. You can set
from the below sequence: exerciser No.( 1 ~ 8 ), weight( KG ), height( CM ), age ( YEAR ),
gender. But, if the meter showing M, the weight will show “lb”,while height will show
“in”.Press MODE to proceed to next parameter setting. Press RECOVERY/UP to increase the
setting value while press DOWN to decrease.
•
When you finish setting, hold the pulse sensor and press RESET/GO. Then the display will
show your body fat in 6 seconds.
•
Press BODYFAT again to exit body fat test.
Remark:
•
During parameters setting, it will exit body fat test automatically if detects no operation
signal over 10 seconds.
•
During body fat test, it will display Er.1 if sense no test target over 10 seconds.
5. AUDIO AMPLIFIER AND SPEAKER [IF HAVE]
Connect the audio input plug to the audio player, the turn on the audio switch that in right side of
the computer. In that case, the audio can be in play.
Body fat contract
MP3
When the MP3 or cellphone connected with the input interface at the side of the computer by stereo
plug, turn
on the audio of the external service and put it to ON,if there’s ON/OFF switch at the side of
the computer ,then, music playing. If no ON/OFF switch here, it will play music automatically.