IP Address & Access to the Web Configuration
14 (24)
5
IP Address & Access to the Web Configuration
5.1
Factory Default IP Settings
Characteristics
Values
LAN IP address
10.0.0.53
LAN subnet mask
255.255.255.0
Gateway
0.0.0.0
The WAN IP address is set by default in DHCP mode.
5.2
Powering On
Power on the unit and wait approximately 2 minutes until the boot process is completed.
After a successful boot process the
USR
LED is blinking green slowly.
If the
USR
LED is blinking red according to a given pattern, it indicates that the boot process was
interrupted due to a problem. The most frequent problem is :
•
a duplicate IP address was detected on the LAN network:
USR
LED blinking pattern is red 1x
short, 1x long
For other error LED patterns, please refer to the General Reference Guide for Cosy+ from the
5.3
Connecting to the LAN IP Address
Establish the first communication with the Ewon Cosy+ by using Ewon Cosy+ companion tool
eBuddy
which can be downloaded from
.
Connect a LAN port (port #1 is always set as a LAN port) of the Ewon Cosy+ to one’s computer
either through a point-to-point connection or a network where there is no risk Cosy+'s default IP
address (10.0.0.53) would conflict with another connected device.
5.4
Ewon Cosy+ Web Interface
While the computer is connected to a LAN port of the Ewon Cosy+, open an Internet browser
and reach the Ewon Cosy+ web server whose URL is the LAN IP address of the Cosy+.
Another way to access the web panel of the Cosy+ is by using eBuddy. To get started with
eBuddy and access the Cosy+, refer to the eBuddy of the
At the very first boot of the Cosy+ or after a level 2 reset, an interface language selection will be
proposed.
Before beginning the configuration of the Cosy+, an authentication is required.
Default login & password are both
adm
. For security reasons, the Ewon Cosy+ will ask you
to change the
adm
password.
You can perform the configuration of your Ewon Cosy+ through different methods:
Ewon Cosy+ Installation Guide
IG-0031-00 1.0 en-US