HMS BE4200, Manual Instruction

Page: 12 / 21

11
(4). Assemble the computer
1.Connect the wire
Connect the Wire (power / control wire) (30) from Handlebar support frame (7) and
with wires from Computer (13) and then press the wires to the computer or handlebar
support frame. (See picture 4)
2.Connect blots
Connect the Computer (13) to Handlebar support frame (7) with 4 sets of Cross head
self-
lock bolt ST4.2*16 (A12), Flat washer Ф4 (C1).
FOLDING INSTRUCTIONS
1)
Folding : The treadmill is foldaway. Lift the end of
the main frame and fold upwards to lock the deck
with the support frame. (See figure a)
2) Moving : Press the handrails to make the front
base foot away from the ground then push the
treadmill after folding.
3) When you want to put the treadmill to the work
position, please unlock the deck and handle
carefully to put it on the floor (see figure
b)
ADJUSTMENT
1. Ask the authorized service representative or professional technician to check if the voltage is suitable, and if the grounded wire
is reliable. Pull the running belt by your hand and check if it turns freely, without screech.
2. Insert one end of the power line into the socket at the forepart of treadmill; plug the other end in the electrical outlet. Put the
emergency stop key on to the corresponding place on the computer.
3.
Turn on the switch from “0” to “1”, the computer displays zero, the running belt do not move.
4.
Press the “ON/OFF” key, the treadmill runs slowly, check if the computer and running belt work normally.
5.
Press the “SPEED QUICK” key, and observe the status of the running belt and display on the computer. Please turn off the
machine if the belt runs defectively, adjust it following the rules in “MAINTENANCE AND MALFUNCTION TREATMENT”.
6. Check all the functions keys on the computer.
7.
Pull out emergency stop key, the treadmill should stop immediately; it’ll work when you put it on again.
8.
Press the “ON/OFF” key, the treadmill will stop, and then turn off the switch if you want to finish your exercise.
OPERATION INSTRUCTION
After assembly and adjustment you can use the treadmill:
1. Turn on the electrical outlet switch, and put the emergency stop key onto the corresponding place on the computer.
2. Stand on the side extrusions; clip the safety key to your clothing at your waist.
3.
Press the “ON/OFF” key, the treadmill runs at a lower speed, you can step on the belt and walk slowly. The lowest speed is
around.
4.
Press the “SPEED UP”, speed of the running belt starts to increase and you can read the speed on the computer. You can run
slowly for 2~3 minutes, and then press
“SPEED UP” to preset speed. You can run freely with hands away from the handrails
when you feel well.( The fastest speed can be achieved 10KM/H)
5. You can directly see the speed, time, distance, and calorie from the computer display during exercising.
6. Slowdown when you want to finish your exercise, and run slowly for 2~3 minutes to make your heart rate and muscle turn to
normal.
7.
If you can’t keep balance while running at a high speed, you can pull off the emergency stop key, and the treadmill will stop
immediately.
8. Do not step on the running belt to right or left during exercise, or else the running belt will be aberrancy.
9. After exercising
, slowdown and press “ON/OFF” key to stop the treadmill. If you want to restart the treadmill, press “ON/OFF”
key (But the interval between start and stop should be more than 1 minute).