14 (26)
4.7
Connecting Digital Output Wires
Before You Begin
The relay output are used to detect user-configured events.
When a user-configured event is triggered, the two wires attached to the
DO
,
fault contacts, form a close circuit.
The fault circuit remains opened until a user-configured event occur.
Procedure
Connect the Digital Output (DO):
1.
Insert the wires into the 2 pin
DO
contact on the
4 pin terminal block
.
2.
Tighten the
wire-clamp screws
.
Anybus
®
Industrial WLAN/LTE Router Startup Guide
SP2557 1.11 en-US
