© HMS Industrial Networks S.L.U - All rights reserved
This information is subject to change without notice
URL http://www.intesis.com
Rev.1.2
2 / 2
Enclosure
Plastic, type PC (UL 94 V-0)
Net dimensions (d
x
w
x
h): 88x106x56 mm
Recommended space for installation (d
x
w
x
h): 130x115x100mm
Color: Light Grey. RAL 7035
Push Button
Button A: Check the user manual
Button B: Check the user manual
Mounting
Wall.
DIN rail EN60715 TH35.
Operation
Temperature
0°C to +50°C
Terminal Wiring
(for power supply and
low-voltage signals)
Per terminal: solid wires or stranded wires (twisted or with
ferrule)
1 core: 0.5mm
2
… 2.5mm
2
2 cores: 0.5mm
2
… 1.5mm
2
3 cores: not permitted
Operational
Humidity
5 to 95%, no condensation
Power
1 x Plug-in screw terminal block (3 poles)
Positive, Negative, Earth
24VDC/AC +/-10%
6W(250mA)
Protection
IP20 (IEC60529)
LED
Indicators
6 x On board LED indicators
1 x Power LED (Green)
1 x DALI (Yellow)
1 x RX (Green)
1 x TX (Yellow)
1 x Button A indicator
1 x Button B indicator
Ethernet
1 x Ethernet 10/100 Mbps RJ45
2 x Ethernet LED: port link and activity
DALI
1 x DALI port (Plug-in screw terminal block 2 poles)
1500VDC isolation from other communication ports
DALI guaranteed power: 230mA
DALI Maximum Power: 250mA
Voltage rating: 16VDC
CONNECTIONS
Power Supply
Must use NEC Class 2 or Limited Power Source (LPS) and SELV
rated power supply. Respect polarity
applied of terminals (+) and (-). Be sure the voltage applied is within the range admitted (check table
below). The power supply can be connected to earth but only through the negative terminal, never
through the positive terminal.
Ethernet / Modbus TCP / Console (UDP & TCP)
Connect the cable coming from the IP network to the connector ETH of the gateway. Use an Ethernet
CAT5 cable. If communicating through the LAN of the building, contact the network administrator and
make sure traffic on the port used is allowed through all the LAN path (check the gateway user manual
for more information). With factory settings, after powering up the gateway, DHCP will be enabled for 30
seconds. After that time, if no IP is provided by a DHCP server, the default IP 192.168.100.246 will be
set.
DALI
Connect the DALI bus to connectors DA+, DA-
of gateway’s DALI port. The Intesis gateway provides
16VDC DALI voltage to the bus. Please, respect polarity when other DALI power supplies are connected
in the same DALI bus.
ELECTRICAL & MECHANICAL FEATURES
This marking on the product, accessories, packaging or literature (manual) indicates that the product contains electronic
parts and they must be properly disposed of by following the instructions at
https://intesis.com/weee-regulation
100 mm (h)
115 mm (w)
130 mm (d)
