1
PRO850 equipment operates in the UHF band from 470 MHz to 740 Hz in 18 MHz subsets. Transmitters and
receivers operate in different, non-adjacent 18 MHz bands. Synthesized frequencies can be selected in 25 kHz
increments over each 18 MHz band, for 720 transmit and 720 different receive frequencies.
This guide will take you through the steps necessary to quickly set up a stand-alone PRO850 system and four
Beltpacs. Once set up, you will be able to operate the system using the default Beltpac settings on a set of
preprogrammed frequencies. Then you can connect the PRO850 base station to a wired intercom system.
This guide assumes that you do not have any saved configuration that you wish to use. It will guide you through
restoring the factory default settings and beginning operation from that point. If this is not what you wish to do,
please refer to your PRO850 Operating Instructions manual.
SECTION 1. INTRODUCTION
