Integration Station Serial Transmitter Page 5
TESTING THE DEVICE WITH PAGING SOFTWARE
This device had been tested to work with QSR, Radiant, Open Table, Pro-Host or any software product that utilizes
the standard TAP, WaveWare, or Scope Paging protocols. To test the device using your paging software, follow the
procedure below…
Add the pagers to the pager list or paging configuration of your existing software. Refer to the list of
pager capcodes on the next page. Be sure to check the pager number, capcode, baud rate and
pager type when you enter the information into your software. The procedure to add pagers to your
paging list is dependent on what software you have. Contact your software reseller for this
procedure if you do not have it.
Anytime you send a page with your software the “Transmit Indicator” will show on the display.
This will confirm that you transmitter was connected properly and compatible with your software.
USING THE DEVICE AS STANDALONE TRANSMITTER
This device can be used as a standalone transmitter in case of software failures. To alert a pager, simply press the
pager number on the transmitter keypad followed by the “send” key. For example, press,
“
11 - send”
and pager #
11 will signal.
Power supply
connector
Transmit Indicator – page being sent
using keypad or thru RS232 port. This
also indicates the Out of Range signal
is being sent.
Keypad
Display
Send button to page
pagers
