12
1
Turn the base station power on, and the beltpac power off .
2
Plug the headset into the beltpac, and put the headset on your head .
3
Press the
REGISTER
button on the base station registration panel .
A lower case “
o
” will appear on the STATUS window .
4
Press and hold the
ALL
button on the beltpac as you press
and release its
PWR
(power) button . After a brief delay, you
should hear “Registration complete” . An ID number for the
beltpac will appear briefly on the STATUS window.
5
Repeat Steps 1 through 4 for each beltpac .
BELTPACS
Beltpac Registration
NOTE:
If registration is not successful, you will hear “Registration failed” and the STATUS
window will be blank . If this happens, refer to
TROUBLESHOOTING
in Section 5,
page 20
.
NOTE:
If you’re attempting to register more than 15 beltpacs to a base station:
●
An “
F
” (Full) will appear in the STATUS window, and you will hear “Registration failed” in
the headset .
●
Clear all current registrations by pressing and holding the
CLEAR/BAND
button while you
press and release the
RESET
button with the point of a pen . Continue holding the
CLEAR/BAND
button after you release the
RESET
button until the clear code “
c
” (lower case) appears on the
STATUS window .
●
Register all beltpacs, one at a time, including previously registered beltpacs .
Power button
ALL button
REGISTER
button
STATUS
window
