HME DX100 EU, Operating Instructions Manual

Page: 10 / 34

5
AC40 BATTERY CHARGER SETUP
The AC40 is the charger for Beltpac batteries.
IMPORTANT!
– Before installing the system, connect the AC power supply to the AC40 Battery Charger
and plug it into an electrical outlet. Charge all the batteries for the Beltpacs while the other equipment is being
installed. Charging time is about 2.5 hours.
Connect AC Power Supply

Attach the AC power supply cable connector to the screw connector on the battery charger.

Plug the power cord connector into the AC power supply.

Plug the power cord into an electrical outlet.
The red lights on the charger will come on and go off, and then the yellow lights will turn on and remain on.
Charging the Batteries
Up to four batteries can be charged simultaneously.
The battery status lights next to each charging port are
explained below.
Up to six fully charged batteries can be stored in the
battery storage ports.

Insert a battery in each of four charging ports
until it clicks in place.

A yellow light adjacent to each charging port
illuminates while the port is empty. When a
battery is in a charging port, an adjacent flashing
yellow light indicates
CHARGE PENDING
,
which indicates that the battery is too hot. Adjust
the room temperature or move the charger to a
cooler area. When a battery is in a charging port,
an adjacent, steady yellow light indicates
CHARGE FAILED
. If this happens, follow the
instructions on the side of battery charger.

A red light adjacent to a battery port indicates
that the battery in the port is
CHARGING
. A
green light adjacent to an inserted battery
indicates a
READY , fully charged battery.
SECTION 2. EQUIPMENT SETUP
Charged batteries
in storage ports
Battery in
charging port
Empty
charging ports
Power cord
connector
AC power supply Power cord
Power supply
cable connector
AC40 Battery Charger
To electrical
outlet