COM6000
COMMUNICATOR
®
REGISTRATION INSTRUCTIONS
Prior to operation of the Wireless 6000 system, each Communicator must be registered for use
with a specific base station. The base station will then recognize all registered Communicators
when their power is on, differentiating between them and interfering transmissions from other
electronic equipment operating on similar frequencies. A maximum of 15 Communicators can
be registered.
Register each COMMUNICATOR
®
as follows:
NOTE:
Communicators must be within 6 feet (1.83 meters) of the base station while being
registered.
Be certain all Communicators to be registered are powered off and the base station power is
on. Other Communicators can be on or off.
Open the base station and press the registration button shown in Figure 1.
⎯
If no Communicators are powered on, the status light shown in Figure 1 will be blinking
red. If any Communicators are powered on, the status light will be on steady green.
⎯
After you press the registration button, the Communicator ID display will show a small
“o” for open and the status light will be blinking green.
HM ELECTRONICS, INC.
14110 Stowe Drive, Poway, CA 92064 USA
•
Phone: 1-800-848-4468 Fax: (858) 552-0172
HME# 400531
Rev A 1/5/04
Communicator ID display
Status light
Reset button
Clear all registration button
Registration button
Figure 1. Registration buttons and indicators in base station
