8
If registration failed:
•
A voice message in the headset will say “Power on, Beltpac #, Version #, Begin registration, …” Both
power lights on the Beltpac will be blinking red, and there may be a delay of up to 90 seconds before you
hear “Registration failed.”
•
Press the
RESET
button on the base station. When the
REGISTRATION STATUS
display becomes
blank, press the
REG
button on the base station and register the Beltpac again. If registration fails again,
call your dealer for assistance.
If you try to register more than 15 Beltpacs
:
•
An
F
will appear on the
REGISTRATION STATUS
display on the base station and you will hear
“Registration failed” in the headset.
•
Clear all current registrations by pressing the
CLR REG
button and the
RESET
button at the same time.
Continue holding the
CLR REG
button after you release the
RESET
button, until the clear code “c” (lower
case) appears on the
REGISTRATION STATUS
display.
•
Register all active Beltpacs, one at a time. Previously registered Beltpacs must be re-registered.
