25
Service & Maintenance
Maintenance Safety Checklist
9
Follow good shop practices.
9
Keep service area clean and dry.
9
Use adequate light for the job at hand.
9
Never work under equipment unless it is blocked
securely
9
Parts replacement should be performed by qualified
personnel to ensure safe and complete installation.
9
A fire extinguisher and first aid kit should be kept
readily accessible.
9
Always use personal protection devices such as eye,
hand, foot and hearing protectors.
9
Use heavy gloves when handling heavy or sharp
components.
9
Ensure power unit is shut off, remove and pocket the
ignition key and parking brakes applied.
Good maintenance is your responsibility. Poor maintenance is an invitation to trouble.
To keep your BK bale knife in good working condition, and increase machine life, periodic lubrication is essential.
Servicing the grease points also helps to flush out moisture and dirt.
By following a careful service and maintenance program for your BK, you will enjoy many years of trouble-free operation.
Replacement of parts should be done by qualified personnel only. Ensure scheduled inspections and maintenance are
performed. Keep a record of all maintenance.
General Maintenance
On a regular basis check all nuts, bolts and screws and ensure they are all properly secured.
On a regular basis check the condition of all hydraulic lines, hoses and fittings. Replace any that are damaged. Re-route
those that are rubbing, pinched or crimped. Tighten any fitting that is leaking. Ensure fittings are clean and free of dirt.
Hydraulic Oil
Hydraulic oil is an important part of your BK. Monitoring your hydraulic oil will prevent hydraulic failures and result in long
lasting equipment with good performance. Hydraulic oil level in the power unit should be checked daily, and the quality
of the oil should be inspected every 50 hrs. If the oil is dirty or smells burnt, it should be replaced. Be sure to relieve the
system of pressure before performing any service to the system. (see your power unit owner manual)
Note
: Do not relieve pressure or bleed the hydraulic system with out securing the cutting arm. The cutting arm requires
pressure to stay in place. Bleeding the hydraulic system will cause the cutting arm to drop.
When working on the BK always secure the cutting arm to prevent unintended movement and possible injury.
!
CAUTION
Operational Hazard
Personal Protection Equipment
(PPE) is required while assembling
or maintaining this machine.
SNL00001
!
WARNING
High Pressure Hazard
Be aware that hydraulic leaks
could develop with out warning. .
Do not check for leaks with your
hand or fingers while the system
is pressurized
SL00015
!
WARNING
Hydraulic Oil Hazard
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can
remain in the hydraulic system after the engine has been stopped. Serious injury can be
caused if this pressure is not released before any service is done on the hydraulic system.
Make sure all of the attachments have been lowered and the oil is cool before removing
any components or lines. All hydraulic
parts replacement should be performed by qualified
personnel.
Summary of Contents for BK48LF
Page 2: ...2 Notes ...
