18
Initial Setup
To prevent potential injury during installation and to ensure safe working conditions, avoid working around the power unit
while it is running. Shut off the power unit and ensure the brakes are applied or the wheels have been secured with wheel
chocks to prevent unwanted movement during the installation process.
The following describes the typical connection procedure with supplied materials. Before proceeding, lubricate all grease
fittings on the unit. Refer to the maintenance section in this manual. Before putting the bale knife into service the first
time, inspect the machine for shipping damage. If damage does exist, do not use. Notify your dealer immediately to have
damaged parts replaced or repaired.
This is a one time set up procedure, and will not have to be repeated.
The initial setup of the BK series involves a few basic steps.
• Install hydraulic hoses
• Prepare and attach the bale knife to the power unit.
• Test and inspect.
Hydraulics
Hydraulic connections from the power unit to the BK are made at the BK. Hydraulic hoses and connectors from the BK to
the power unit is the responsibility of the owner.
The following describes the typical connection procedure, however customizing the connections is possible (mid mount
loader valve, etc) and is up to the customer. See your power unit manual on how to operate your auxiliary hydraulics.
Caution: only qualified personnel should make modifications and connections to the power units hydraulic system.
• The hydraulic hoses must be:
• Good quality, 3000 psi max
•
Sufficient length to reach the auxiliary ports
• 3/8 i.d. minimum.
•
BK end of the hose must have 1/2” NPT fittings
•
Power unit end, connectors to fit your auxiliary
ports.
• At the power unit, route the hydraulic hoses from the
power units auxiliary remote hydraulic connections to
the BK connection at the check valve.
• Do not lock the auxiliary hydraulics in the “ON” .
• Ensure the hydraulic hose is secured and protected
from snags, crimping or pinching.
• Mark the connections appropriately on the hoses.
!
CAUTION
Operational Hazard
Do not lock the auxiliary hydraulics in the
“ON” position, dangerous and unexpected
movement will occur.
!
CAUTION
Operational Hazard
At first use the hydraulic cylinders and hoses on this
product may contain air or an air-fluid mixture. Failure
to remove all the air from the hydraulic cylinders can
cause dangerous uneven, jerky cylinder movement
during use or unwanted cylinder movement when not
being operated.
Check valve
Hydraulic
connection
!
WARNING
High Pressure Hazard
Be aware that hydraulic leaks
could develop with out warning.
Do not check for leaks with your
hand or fingers while the system is
pressurized
SL00015
Summary of Contents for BK48LF
Page 2: ...2 Notes ...
