Glue nose rib in place.
Wait with Glue in rib 1. This rib will be glued in when midsection
and tip are glued together.
Glue the leading edge strip in place.
After the glue dried, get the tip(s) from the building board.
Sand careful the leading edge.
Building Center part Wing.
Tape plan on building board.
Put plastic sealing over it.
Pin the trailing edge on the building board.
Cut from 1,5 mm balsa underside of the wing back from the spar to trailing edge.
From spar to trailing edge we will do later.
Cut spar (spurce) in length and glue to 1,5 mm balsa
