CLEANING AND STORAGE
l
In addition to this, you must refer to the security precautions.
l
Do not clean Motor main body, power cord and plug with water.
l
Clean the engine base with a soft, wet piece of cloth and some mild
cleaning agent.
l
Fill the jug half-full with hot water and a little cleaning agent. Let the
unit run on speed 2 until the jug is clean.
l
The jar base bottom with the blades can be taken apart. Screw off the
base bootm counter-clockwise which is marked “un-lock” on the
bottom. Take out the blades together with sealing ring facing
upwards.
l
Now clean jug, cover, closure, base and blades with sealing ring with
hot water and some cleaning agent. Dry well before re-using. Caution!
The blades inside of the jug are very sharp.
l
Never use aggressive cleaning agents.
Warning :
Do not to touch the sharp blade. When clean, please wipe by dishcloth, to avoid accidentally injure
.
Note :
1.
Unit suitable for household only.
2.
Overheat protection
In order to prolong the device’s service life, an overheat protecting unit is installed. If the motor
runs too long or overloaded, the temperature reaches the warning value and the motor will stop
automatically. Pull out power supply plug and wait for the motor to cool (about 20 to 30 minutes),
then use again.
If you have any problem with this device, do not disassemble it by yourself. Always contact the
service department or after-sale service department.
3.
Do not use for commerce. Otherwise the maintain service will invalid.
CLEANING
Cleaning the Blender Jug
1.
Pour about 500ml of warm soapy water into the jug and place the jug on the base.
2.
Use the pulse mode to loosen any food particles and free them from the blades.
•
Remove the jug, pour away the water and rinse in fresh running water.Repeat steps 1
and 2 with fresh water.
•
Alternatively the jug may be immersed in warm soapy water and cleaned using a long
handled brush. Do not touch the blades when cleaning.
•
Wash the lid and measuring cup separately in warm soapy water, rinse and allow to dry.
