Copyright HK Instruments 2017
www.hkinstruments.fi
Installation version 5.0 2017
STEP 3: CONFIGURATION
CONFIGURATION
CONTINUED
Configuration of the RHT Duct series device consists of:
Configuration menu options. (Display versions only.)
Press the select button to accept changes. Move to the next set
-
ting by pressing the down button.
1) Activate the device Menu by pushing the select button for 2
seconds.
2) Select the humidity low limit for output band: 0...90 %.
For CE compliance a properly grounded shielding cable is
required.
1) Unscrew the strain relief and route the cable(s).
2) Connect the wires as shown in figure 2a.
3) Tighten the strain relief.
rH
T
24 V
GND
+ Power Supply
24VDC / 24VAC
Output 0/2...5/10 V
Output 0/2...5/10 V
rH OUT MIN
0.0 %rH
SELECT
UP
DOWN
3) Select the humidity high limit for output band: 10...100 %.
rH OUT MAX
100.0 %rH
SELECT
UP
DOWN
4) Select the temperature low limit for output band: 0...45.0 °C or
32...112 °F.
TE OUT MIN
0.0 °C
SELECT
UP
DOWN
5) Select the temperature high limit for output band: 5...50.0 °C
or 42...122 °F.
6) Select the output maximum voltage: 5 V / 10 V.
TE OUT MAX
50.0 °C
SELECT
UP
DOWN
MAX OUTPUT V
10 V
SELECT
UP
DOWN
7) Select the output minimum voltage: 0 V / 2 V.
MIN OUTPUT V
0 V
SELECT
UP
DOWN
8) Push the select button to exit menu.
SELECT
EXIT MENU
SELECT
WARRANTY POLICY
The seller is obligated to provide a warranty of five years for the deliv
-
ered goods regarding material and manufacturing. The warranty period
is considered to start on the delivery date of the product. If a defect
in raw materials or a production flaw is found, the seller is obligated,
when the product is sent to the seller without delay or before expira
-
tion of the warranty, to amend the mistake at his/her discretion either
by repairing the defective product or by delivering free of charge to the
buyer a new flawless product and sending it to the buyer. Delivery costs
for the repair under warranty will be paid by the buyer and the return
costs by the seller. The warranty does not comprise damages caused by
accident, lightning, flood or other natural phenomenon, normal wear
and tear, improper or careless handling, abnormal use, overloading, im
-
proper storage, incorrect care or reconstruction, or changes and instal
-
lation work not done by the seller or his/her authorized representative.
The selection of materials for devices prone to corrosion is the buyer’s
responsibility, unless otherwise is legally agreed upon. Should the man
-
ufacturer alter the structure of the device, the seller is not obligated to
make comparable changes to devices already purchased. Appealing for
warranty requires that the buyer has correctly fulfilled his/her duties
arisen from the delivery and stated in the contract. The seller will give
a new warranty for goods that have been replaced or repaired within
the warranty, however only to the expiration of the original product’s
warranty time. The warranty includes the repair of a defective part or
device, or if needed, a new part or device, but not installation or ex
-
change costs. Under no circumstance is the seller liable for damages
compensation for indirect damage.
STEP 2: WIRING DIAGRAMS
RECYCLING/DISPOSAL
The parts left over from installation should be
recycled according to your local instructions.
Decommissioned devices should be taken to a
recycling site that specializes in electronic waste.
Figure 2 - Wiring diagram
SELCOUSA.com
