Copyright HK Instruments 2016
www.hkinstruments.fi
Installation version 3.0 2016
SCHEMATICS
DIMENSIONAL DRAWINGS
INSTALLATION
STEP 1: MOUNTING THE DEVICE
1) Mount the device in the desired location (see step 1).
2) Route the cables and connect the wires (see step 2).
3) The device is now ready for configuration.
WARNING! Apply power only after the device is properly wired.
1) Select the mounting location (on a duct).
2) Use the mounting flange of the device as a template and mark
the screw holes.
3) Mount the flange on the duct with screws (not included). (Figure
1a)
4) Adjust the probe to the desired depth. Ensure that the end of
the probe reaches the middle of the duct. (Figure 1b)
5) Tighten the screw on the flange to hold the probe in position.
Figure 1a - Mounting a flange
Tighten the
screw
Figure 1b - Mounting the probe in a flange
Air flow direction
Air flow direction
Air flow direction
Air flow direction
Air flow direction
Strain relief facing down
Figure 1c - Mounting orientation
Display connection
Terminal block
A
B
24 V
GND
Joystick 1
Joystick 2
Joystick 3
Select
Up
Down
Menu buttons
