Back Panel Controls
SEND –
For connection to the input of an external
effects pedal, rack or processor. The “Loop” switch on
the footswitch allows you to bypass the external
effect.
RETURN –
For connection to the output of an
external effects pedal, rack or processor.
FOOTSWITCH REVERB / LOOP –
By
connecting the supplied footswitch to this jack it is
possible to turn on the Reverb and bypass or use the
Effects Loop (Send, Return).
FOOTSWITCH CH1/CH2 / HI GAIN –
By
connecting the supplied footswitch to this jack it is
possible to change between Channel 1 and Channel
2, and controls the switchs on the front panel. The
footswitch will override the front panel switchs.
EXTENSION SPEAKER –
Connection for an
external speaker cabinet. This jack puts the extension
speaker in parallel with the main speaker. Check the
correct selection for the speakers on item 7.
MAIN SPEAKER –
Connection for the primary
speaker (internal or external).
DO NOT OPERATE WITHOUT A LOUDSPEAKER
CONNECTED.
IMPEDANCE SELECTOR –
Select the correct
impedance according to one of the possible
configurations below:
One 4 Ohm cabinet, set to 4 Ohms;
One 8 Ohm cabinet, set to 8 Ohms;
One 16 Ohm cabinet, set to 16 Ohms;
Two 8 Ohm cabinets, set to 4 Ohms;
Two 16 Ohm cabinets, set to 8 Ohms;
FAILURE FUSES –
The fuse must be replaced
when the LED is ON. If the fuse blows after be replaced
try changing the output valves.
HT FUSE –
Protects the DC power to the tubes
within the amplifier. Have the amplifier tested by a
qualified technician if it repeatedly blows fuses.
VOLTAGE SELECTOR/MAIN FUSE –
Make
sure the specified voltage is correct for your country!
Use only the correct size and rating fuse as specified
on the panel.
MAINS PLUG –
Connect the mains lead to your
power source.
HI
-G
AI
N
SERI
ES
HI
-G
A
IN
50 &
100
Pg 5
