10
IOM_WPVBZ HE-WPVZ HE_401-1201-4002_208110_200901_EN
PACKAGED COMPACT VERTICAL
– WATER / AIR
WPVBZ HE / WPVZ HE
TRANSPORT
INSPECTION AT RECEPTION
It is advisable to check the equipment carefully upon reception.
Check that the equipment has not been damaged during transport and has been supplied complete with all parts
specified in the order and/or with the optional specified in the order. If this is not the case contact the transport
company immediately (within 48h)
Verify the correct voltage of the nameplate and make sure it is in accordance with the local power supply.
In case of any flaw or anomaly detected, please contact HITECSA.
RIGGING
Before moving the unit make sure that all the panels are fixed correctly.
Raise and set down the equipment carefully.
Do not tilt the unit more than 15 degrees during transportation, (Pict. 2).
Always transport the unit in its original packaging to the place of installation.
All units come with a particular rigging diagram of that model similar to the one shown below. Be sure to hoist the
machine through the points indicated in the diagram.
Make sure that the unit is balanced, stable and without any deformations when it is lifted.
STORAGE
If the equipment is going to be stored before the installation, please follow the instructions below in order to avoid damages,
corrosion or deterioration:
Move it carefully.
Do not place the machine in places exposed to ambient temperatures above 50ºC and preferably keep the unit away
from direct sunlight.
Avoid placing the unit with plastic wrapping protection under the sun as the pressure of the circuits could assume
values that could lead to the intervention of the safety valves.
In addition, when cooling, water condensation occurs inside the machine and the plastic wrap.
Avoid placing other objects on top of the unit (unless it is done within the limits of the overlap planes indicated on the
packaging, etc. Follow these indications).
Avoid prolonged storage before installation, water penetration, dust and objects in general due to invasion or
biological, meteorological and/or human impacts.
Minimum storage temperature: 5ºC.
Maximum relative humidity: 90%.
The warranty will not cover any damage caused by frozen water.
WARNING
Fig. 1
Fig. 2