09
When powered on for the first time the X2-400 will load a set of default parameters most
commonly used by most users. The screen displays the information in the following
sequence. The user can customize the parameters on each screen to suit their own
preferences.
To change the parameter values in the program, press the
Start/Enter
key to choose the
parameter you want to change. Once the parameter is blinking you can change the value
with the
INC
(up/forward) or
DEC
(down/back) keys. The value will be stored by pressing
the
Start/Enter
key once and the blinking stops.
WARNING
DO NOT CONNECT A BATTERY TO THE CHARGER BEFORE SETTING
UP THE DEFAULT USER PREFERENCES
Main User Setup Screen
The first screen displayed is the Lithium battery set-up screen, you
can press
ENTER
to bypass this screen and go to the next user
setup screen, or you can set the default Lithium battery type before
moving on.
The Lithium Battery Select Screen
Here you can choose one of the three kinds of Lithium batteries
supported by the X2-400, LiFe (3.3V), Lilo (3.6V) or LiPo (3.7V). If
you plan to use one type of Lithium chemistry battery you can set the
default here.
WARNING:
Make sure when you connect your battery
that you have selected the proper type of battery before you begin
charging your battery. Once you have established the desired
settings press
Start/Enter
to confirm the setting then press
INC
to
move on to the next parameter.
LiPo /LiIo/LiFe Check Time
To avoid an erroneous setting by the user the X2-400 will automati-
cally detect the cell count of a Lithium battery at the beginning of the
charge or discharge process. To prevent an over-discharged battery
from being detected incorrectly, resulting in an error, you can set a
time limit for the processor to verify the cell count. The default setting
is 10 minutes which is typically enough time to properly detect the
cell count. It is not recommended that you change this setting as
setting to long of a “Check Time” can produce dangerous results.
Once you have established the desired settings press
Start/Enter
to
confirm the setting then press
INC
to move on to the next parameter.
DEFAULT USER PREFERENCES SETUP
DEC INC
ENTER
DEC INC
DEC INC
Summary of Contents for Multi-Charger X2-400
Page 1: ......
Page 14: ...12 PROGRAM FLOW CHART...
Page 28: ...All specifications and figures are subject to change without notice...
