7
1. Remove the jumper from the HG3XA.
2. Switch on the transmitter and then your model.
3. If the blue and red LED flash once, the HG3XA is in reverse.
4. Reverse Setting Menu:
a. The LEDs start to flash in a rotary pattern after one
second. The color indicates the current gyro system
setting. Blue represents “Standard” and red “Reverse.”
b. Aileron: the blue or red LED flashes once every second
for a total of five times. While the LED is flashing, you
can change the direction of the aileron function by
moving the left-hand rudder stick to the left or right.
Hold the rudder stick in the end position until the color
of the LED changes and the setting has been saved.
c. Elevator: the blue or red LED flashes twice every second
for a total of five times. While the LED is flashing, you
can change the direction of the elevator by moving
the left-hand rudder stick to the left or right. Hold the
rudder stick in the end position until the color of the
LED changes and the setting has been saved.
d. Rudder: the blue or red LED flashes three times every
second for a total of five times. While the LED is flashing,
you can change the direction of the rudder by moving
the left-hand rudder stick to the left or right. Hold the
rudder stick in the end position until the color of the
LED changes and the setting has been saved.
5. Change the control directions of the HG3XA:
a. To change the control directions of the gyro,
move the left-hand rudder stick to the left
or right. While the LEDs are flashing, you
can toggle between the “Standard” and
“Reverse” settings.
b. The LEDs continue to flash until you release
the rudder stick.
6. Exit Set-up mode
You can exit the Set-up mode at any time by
switching off the device. Remember to re-insert
the jumper in the correct slot for model type
selection.
Reversing Instructions
