-
Function Button
: Use this button when to combine the OPTIMA receiver and the built-in FHSS 2.4GHz module or to Set normal/scan mode or Power off when check
the range.
Features of OPTIMA Series Rx
OPTIMA 6, 7 receivers are compatible with built-in FHSS 2.4GHz module of FLASH 7 and They have many necessary functions for the 2-way
communication radio control.
-
2-way communication sensor and System terminal
: The sensor station collect the data that 2-way communication sensor sent and Data is transferred to the FLASH 7 through the data 3pin of
OPTIMA7 receiver. You can upgrade the software of your Tx or send data of your sensor station to the PC if you extra purchase the HPP-22.
-
Function Button
: OPTIMA receiver and built-in FHSS 2.4GHz module are used to set Fail-Safe/Hold function.
-
Display Dual LED status
: This function displays the LED status or indicate the Code in progress Set-up.
-
SPC auxiliary power connection
: SPC auxiliary power connection can supply motor power until 35V to OPTIMA Rx. Please refer to the detailed description about SPC function.
-
Channel output and input terminals of batteries
: The OPTIMA is connected batteries, servos, gyro and other equipments.
-
Jumper
: A Jumper of Rx is mounted in the factory and It is used to supply power by the general BEC(Battery Eliminator Circuit) of electronic
transmission or 4.8 to 6 volt Ni-MH battery pack or battery Li-PO 2Cell.
(Warning – The Servo ability is different according to the part of regulator capacity and stable power supply of receiver. Please check this
always.)
-
Normal / Scan mode selection
: You can select Normal / Scan mode by 2.4GHz signal type..
-
Fail-Safe Specifications
: This function is operating servo or peripheral on Fail-Safe status if signal of Tx is quit.
Summary of Contents for Flash 7
Page 1: ......
