Hitec Luxembourg S.A. |
5, Rue de l’Église, L-1458 Luxembourg
www.hitec.lu | [email protected] | Tel.: (+352) 49 84 78 - 1 | Fax. (+352) 401303
File Name: HTCA_003-DADS-UserManual.docx
Document Type: End User Manual | Version date: 01/05/2010 | Last Printed: 15/02/2011
Page 47/81
Details
Before the last measurements can be visualized,
or a new Normalization measurement can be
done, the
type of carbon-black
(Method) has to
be chosen. This is done on the window of Figure
14.
After the choice of the carbon-black type the
window below is displayed. It shows the carbon
black type and the
latest Normalization
measurements
which have been done.
The
Normalization measure
can be started by
either clicking on the
“
New measure
”
button, or
by pushing the
“
Enter
”
key of the DADS
terminal.
The Normalization measure is done like all
other absorption measures. See the section
How to do a test? to get more information
about the different possibilities.
After the measurement the application does
some
verification
on the test results, in order
to check the validity of the test. In case the test
has not been valid an error message is
displayed.
After the measurement the results will be shown, like for a normal test. The user has to
decide if this Normalization measurement should be
accepted or rejected
.
An accepted measurement is recorded and will be used for the Normalization calculation. It
will appear on the list of the four last measurements.
A rejected test will not be recorded and used for the Normalization calculation. This
measurement will just be logged with the other Normalization measurements in the log list.
Refer to Normalization Trend to get more information.
By pressing on one of the
buttons the details of these measurements can be visualised in
Retrieve mode and the user can print out the report.
If a bad measure was accepted by mistaken, the user has the possibility to delete it by
clicking on the “
Undo last Norm.
” button and the last will be removed from the list.
Figure 14
– Normalization measure selection
