-16-
•
Removal of magnet (G) and the armature and pinion set
6. Disassembly of the switch
Disconnect the internal wires (red and black) coming from the Brush Block
[25]
from the Switch
(W/Controller and Tube)
[34]
by unsoldering.
NOTE: Do not remove the switch and the controller from the Switch (W/Controller and Tube) [34].
7. Removal of magnet (G) and the armature and pinion set
(1) Remove Magnet (G)
[23]
in the "B" direction as shown below holding the Ring Gear
[21]
securely
because Magnet (G)
[23]
has a strong magnetism. Dust Guard Fin
[24]
and the side yoke can be easily
removed from Magnet (G)
[23]
by holding Magnet (G)
[23]
securely and pulling them in the axial
direction because they are mounted to Magnet (G)
[23]
magnetically.
(2) Support the Ring Gear
[21]
so that it does not contact the fan of the Armature and Pinion Set
[22]
. Push
down the tip portion of the Armature and Pinion Set
[22]
(pinion) to remove it.
Brush Block
[25]
Magnet (G)
[23]
Ring Gear
[21]
B
Pinion
Dust Guard Fin
[24]
Armature and Pinion Set
[22]
