Hitachi WH 8DC2, Instruction Manual

Page: 15 / 24

15
REMOVAL AND INSTALLATION METHOD OF BATTERY
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make
sure the following points.
䡬
The power source voltage is stated on the
nameplate.
䡬
The cord is not damaged.
WARNING:
Do not charge at voltage higher than
indicated on the nameplate.
If charged at voltage higher than indi-
cated on the nameplate, the charger
will burn up.
1. Insert the plug of battery charger into
the receptacle.
When the plug of battery charger has
been inserted into the receptacle, pilot
lamp will blink slowly. (At 1-second inter-
vals.)
Fig. 10
Fig. 9
Pilot Lamp
Nameplate
䡬
How to remove the battery.
Hold the handle tight.
Press the latch located at the front of the
battery and pull out the battery. (Fig. 9)
䡬
How to install the battery.
Position the battery so that the latch faces
toward the switch trigger in the handle
and insert the battery. (Fig.9)
Handle
Insert
Pull out
Latch
Battery