Running the Initial Setup wizard
The Initial Setup wizard allows you to configure system information, date and time
settings, and network settings.
The Initial Setup wizard settings are presented on three windows. Buttons at the
bottom of each window allow you to apply or skip the settings on that window. If you
skip settings, you can complete them later by running the Initial Setup wizard again. To
display details about the settings in the windows, click the question mark icon in the
bottom right.
Before you begin
Log in to Storage Advisor Embedded, and then open the maintenance utility by clicking
the gear icon at the top-right corner and selecting User Administration.
Procedure
1. In the maintenance utility navigation tree, under Menu, click Initial Setup Wizard.
Tip: Initial Setup Wizard is near the bottom of the navigation tree. If
you do not see this selection, scroll down the tree.
2. At the bottom, click Skip this step two times to bypass the Set Up System
Information and Set Up Date & Time screens.
3. In the Set Up Network Settings screen, enter the IPv4 or IPv6 configuration
settings for the production network to which the storage system will be connected.
For example:
Running the Initial Setup wizard
Installing your storage system
Storage system installation (without SVP)
19
