Identifying Hardware Components
2–9
Hitachi Simple Modular Storage 100 User’s Guide
For normal operation, the mode switch should be in the
N
position. The
E
position is used when you need to migrate data from one dual-controller
Hitachi Simple Modular Storage 100 to another. The back panel
C-PWR
LED
then goes OFF and the
EXT
LED goes ON to show that the array is in
migration mode. For more information, see
•
•
Figure 2-9: Location of MODE Switch and EXT LED on the Back Panel
Top Components
The top of your Hitachi Simple Modular Storage 100 may have cautions,
product information labels, and/or agency certifications.
NOTE:
When you move the
MODE
switch to the
E
position, a question
mark (?) appears for the status shown for the array in Storage Navigator
Modular 2 to show that the array is in migration mode.
EXT LED
MODE Switch
Summary of Contents for Simple Modular Storage 100
