49
How To Remove Parts / How to Maintain the Automatic Ice Maker
Tap water
Mineral water, well water, water purifi ed by water purifi er, cooled
boiled water, etc. (water which doesn't contain chlorine)
Once a week
Once three
days
3
HOW TO MAINTAIN THE AUTOMATIC ICE MAKER
Washing the supply channel (Ice Maker Cleaning)
Cleaning the ice tray
●
Maintain it once a year
Cleaning the water supply container
Ice tray and water supply line can be washed.
Be sure to check the followings before starting the operation.
Go to the next step after checking them.
●
When using for the fi rst time
●
When not used for more than one week
●
Recommended maintenance intervals
●
Remove the seal from the lid and wash it with a soft wash sponge.
●
How to open the lid
●
How to open the lid
1
1
1
Push the
button and hold it for more than
5 seconds after closing all the doors and
turning on the display.
When the three indicator lamps
急速製冰
(Quick Ice Making) ,
製冰
(Ice
Making) and
停止
(Stop) start to blink and alarm starts to sound, stop
holding the button.
製冰機清潔
(Ice Maker Cleaning) starts.
Lay a soft clean towel on the bottom
of the ice case.
The purpose is to absorb water discharged during
ice maker cleaning and prevent water spill.
Before removing the case, wipe
off the water in the case.
Push the
button to stop supplying water to the ice tray
and turn on the
停止
(Stop) indicator lamp. (Stop ice making)
Empty the ice tray and wash it lightly in the stream.
Push the
button to light the
製冰
(Ice Making) indicator
lamp. (Automatic
Ice Making starts)
Turn the case and remove it
from the lid.
Pull the tab of the water
fi lter with fi ngers and
remove it from the case.
Wash it with a soft
wash sponge etc.
About three minutes later, when alarm and blinking
end, remove water in the ice case using the towel.
Open the Ice Compartment Door.
①
Push the level laterally.
②
draw the frame.
③
Raise the cover (
▲
part) in the direction of the arrow.
④
Remove the ice tray from the frame.
・
The indicator lamp will fl ash and the buzzer will sound for about 3 minutes.
・
製冰機清潔
(Ice Maker Cleaning) can’t be interrupted.
・
If you open any of the refrigerator doors during Ice Maker Cleaning, the cleaning
may not work properly. Do not open or close the door until cleaning is completed.
・
Door alarm sounds even if alarm is disabled.
Pg.54
Water which doesn't contain chlorine may easily cause slime and/or fur
compared with tap water. Wash the Water Supply Container regularly to
prevent bacteria from breeding when such water is used.
There is no problem with using water remaining
in the water supply container, if any.
※
If the indicator lamp
fl ashes, perform the
following operation after
the “
停止
(Stop)” lamp is
turned on in 1 minute.
2
2
2
3
3
●
Water supply container
・
Water is fi lled in it.
・
The container is set properly as specifi ed.
●
Ice case
・
If there remains ice, remove it.
Water supply
cover
Seal
(Front)
Insert the lid from its rear side and
close it in the direction of the arrow.
(Back)
Lid
Case
Water fi lter
Water supply
container
To prevent malfunction, lay the
towel so that its thickness does
not reach this line.
Container-full
line
Add water line
Tab
Cleaning the water fi lter
(Replace it normally every 3
〜
4 years.)
Pg.53
Do not use the
detergents etc.
Do not use any cleaning
tool that can scratch it easily
such as scrubbing brush and
plate powder.
●
If you set ice making to Stop and do not intend to
use the auto ice maker for some time, wash and dry
the water supply container and then mount it in place.
●
In particular, dry the water fi lter thoroughly.
Notice
Cover
4
Frame
Lever
Click
①
Set the ice tray and
②
close the cover.
③
Make the frame horizontal and push
it into the end (The level is automatically
restored to its original position.)
●
When the frame for the ice tray cannot be pushed into the back, the motor that drives the ice-tray may have operated.
Remove the ice tray and then push the frame alone into the back, and then push the
with all the doors opened to
turn on
停止
(Stop) . After a while, the ice-tray driving motor gets ready, allowing you to mount the ice-tray.
Notice
●
Do not place your hand in the mechanical
section of the automatic ice maker.
(Rotation of the ice tray may cause injury.)
Warning
About
5 seconds
1 beep
Push this button for
more than 5 seconds
4 long beeps
Light ON
Push this button to turn on the
停止
(Stop) indicator lamp.
Push this button to turn
on the indicator lamp
Light ON