– 6 –
NAMES AND FUNCTIONS OF EACH PART
REMOTE CONTROLLER
●
This controls the operation of the indoor unit. The signal range of control is about 7 meters. If inverter
lamp is used, the range of control may be shorter, in some cases, the control signal may not be received.
This unit can be
fi
xed on a wall using the
fi
xture provided. Before
fi
xing it, make sure the indoor unit can
be controlled from the remote controller.
●
Handle the remote controller with care. Dropping it or getting it wet may compromise its signal transmission
capability.
●
After new batteries are inserted into the remote controller, the unit will initially require approximately 10
seconds to respond to commands and operate.
Transmission sign
The transmission sign blinks when
a signal has been send.
Signal Transmission
FUNCTION Selector
Use this button to select the
operating mode. Every time
you press it, the mode will
change from
(AUTO) to
(COOL) to
(HEAT) to
(DEHUMIDIFY) and to
(FAN) cyclically. (
Page 7)
ECO Button
Use this button to set the ECO
mode. (
Page 13)
RESET Button
SLEEP Button
Use this button to set the
sleep timer. (
Page 14)
OFF TIMER Button
Select the turn OFF time.
(
Page 12)
ON TIMER Button
Select the turn ON time.
(
Page 12)
Precautions for Use
●
Do not put the remote controller in the following places.
●
In direct sunlight.
●
In the vicinity of a heater.
●
Handle the remote controller carefully. Do not drop it on the
fl
oor, and protect it from water.
●
Once the outdoor unit stops, it will not restart for about 3 minutes (unless you turn the power switch
off and on or unplug the power cord and plug it in again).
This is to protect the device and does not indicate a failure.
●
If you press the FUNCTION selector button during operation, the device may stop for about 3 minutes
for protection.
POWERFUL Button
Press this button to start powerful
operation. (
Page 12)
FAN SPEED Button
Select the fan speed for cooling
and heating mode. (
Page 11)
START/STOP Button
Press this button to start
operation. Press it again to stop
operation.
AUTO SWING (Horizontal) Button
Control the angle of the horizontal
air de
fl
ector. (
Page 15)
AUTO SWING (Vertical) Button
Control the angle of the vertical
air de
fl
ector. (
Page 15)
TEMPERATURE Button
Room temperature setting.
Value will change quicker when
keep pressing.
RAS/RAC-PH30HLT (1-16).indd 6
RAS/RAC-PH30HLT (1-16).indd 6
