Hitachi P 14 DSL, Handling Instructions Manual, Page: 9 / 20

9
○ Either install the battery in the power tool or store
by securely pressing into the battery cover until the
ventilation holes are concealed to prevent short-
circuits (See Fig. 5).
REGARDING LITHIUM-ION BATTERY
TRANSPORTATION
When transporting a lithium-ion battery, please observe the
following precautions.
WARNING
Notify the transporting company that a package contains a
lithium-ion battery, inform the company of its power output
and follow the instructions of the transportation company
when arranging transport.
○ Lithium-ion batteries that exceed a power output of
100Wh are considered to be in the freight classi fi cation
of Dangerous Goods and will require special application
procedures.
○ For transportation abroad, you must comply with
international law and the rules and regulations of the
destination country.
Wh
Power Output
2 to 3 digit number
SPECIFICATIONS
POWER TOOL
Model P14DSL P18DSL
Cutting Width 82 mm
Max. Cutting Depth 2.0 mm
No-load speed 16000 /min
Rechargeable
battery
2LSRK BSL1430: Li-ion 14.4 V (3.0 Ah 8 cells) BSL1830: Li-ion 18 V (3.0 Ah 10 cells)
2LJRK BSL1450: Li-ion 14.4 V (5.0 Ah 8 cells) BSL1850: Li-ion 18 V (5.0 Ah 10 cells)
2LYCK — BSL1860: Li-ion 18 V (6.0 Ah 10 cells)
Weight 3.2 kg (With BSL1430) 3.3 kg (With BSL1830)
CHARGER
Model UC18YFSL UC18YSL3
Charging voltage 14.4 V – 18 V
Weight 0.5 kg 0.6 kg
USB DEVICE CONNECTION PRECAUTIONS
(ONLY WITH UC18YSL3 CHARGER)
When an unexpected problem occurs, the data in a USB
device connected to this product may be corrupted or lost.
Always make sure to back up any data contained in the USB
device prior to use with this product.
Please be aware that our company accepts absolutely no
responsibility for any data stored in a USB device that is
corrupted or lost, nor for any damage that may occur to a
connected device.
WARNING
○ Prior to use, check the connecting USB cable for any
defect or damage.
Using a defective or damaged USB cable can cause
smoke emission or ignition.
○ When the product is not being used, cover the USB port
with the rubber cover.
Buildup of dust etc. in the USB port can cause smoke
emission or ignition.
NOTE
○ There may be an occasional pause during USB
recharging.
○ When a USB device is not being charged, remove the
USB device from the charger.
Failure to do so may not only reduce the battery life of a
USB device, but may also result in unexpected accidents.
○ It may not be possible to charge some USB devices,
depending on the type of device.
000Book̲P14DSL.indb 9 000Book̲P14DSL.indb 9 2017/12/04 15:25:13 2017/12/04 15:25:13