--- 32 ---
(b) Reassembly
Disassembly procedures should be followed in the reverse order. Note the following points.
When inserting the Roll Pin D4 x 32 [80] into Nail Feeder (B) [81], be careful that the end of the Roll Pin
D4 x 32 [80] is not stick out from Nail Feeder (B) [81]. Insert the Feeder Spring [85] between the protrusion of
Nail Feeder (A) [79] and the protrusion of Nail Feeder (B) [81].
Fig. 24
Protrusion
Nail Feeder (B) [81]
Nail Feeder Ass'y [88]
Roll Pin D4 x 32 [80]
Protrusion
Nail Feeder (A) [79]
Feeder Spring [85]
Fig. 25
(3) Disassembly and reassembly of the cap (See Fig. 25.)
[Tool required]
Hex. bar wrench (4 mm)
(a) Disassembly
Remove the three Hex. Socket Hd. Bolts M5 x 16 [42], then the Cap [41] and Gasket (B) [40] can be
removed.
(b) Reassembly
Reassembly can be accomplished by following the disassembly procedures in reverse.
Body Ass'y [24]
Hex. Socket Hd. Bolt
M5 x 16 [42]
Cap [41]
Gasket (B) [40]
Summary of Contents for NR 90AD (S)
Page 42: ......
